- Compatibility of the gun: You should know the various gases which are compatible with your gun. Guns made especially for HFC134a gases are weaker inbuilt. They cannot generally withstand the pressure of the green or red gas and can break down. It’s ok to use green gas, but using red gas needs a superior built material. CO2 gas is the strongest gas used in a gas gun.
- Application of gas: Incorrect application of gas can lead to freezing up of the O-Rings. Black rubber seals at the magazines valves are termed as O-rings. Any discrepancy in the O-ring can lead to leakage of gas from the magazine. You should always apply the gas in the second burst after holding the magazine in the upright direction. If you apply the gas for more than 5 seconds. There are high chances that it may freeze the O-rings.
- If there is gas in the magazine, then never press the release button: The gas release button is provided to release the magazine from the gun. If there is still any gas in the magazine and you press the gas release button, then it can freeze the O-ring seal. This can lead to permanent damage on the seal and gas leakage from the gun.
- Remember that the O-rings can be replaced: Many people just throw away the whole magazine on the sight of a damaged O-ring. Magazines are quite expensive, and on the other hand, O-rings come at a fraction of its cost. You should use silicon oil for the lubrication of these rings. They can be easily purchased from your local market or the online stores. Just make sure that the size of O-rings you buy matches the original one.
Another important thing is to keep all the
moving parts of your gun lubricated. Silicon oil is the best lubricant used for
the guns. Airsoft guns gas should be
handled carefully to avoid any leakages from the gun.
0 comments:
Post a Comment